Showing posts with label inspection. Show all posts
Showing posts with label inspection. Show all posts
Monday, November 8, 2010
Keeping a Close Eye on Your Home Heating
Be Heat Vigilant and Observant This Fall and Winter!We tend to take our hot water and home heating for granted, but when something goes wrong with our home heating systems, we can easily go into panic mode. The professionals need to be contacted in some cases, but for a lot of smaller matters it’s possible with a few basic tools and some elementary knowledge of how the system works to fix the problem ourselves and save time as well as money. Here are the some of the things you need to be aware of and be prepared for before and during heating season.
The main components of any home heating system are the heat source, the system for distributing the heat and finally the thermostat which controls the temperature. A breakdown of any of these three will seriously interfere with your comfort and convenience.
A simple loss of power may be the cause of a failure in the furnace or boiler which supplies the heat in the first place. The fuel needed by the unit for it to work may not be reaching it. Even if it is reaching it, ignition may be the problem in the case of gas or oil. Or everything may be fine with the heat source but the heat itself is not reaching its destination, which would point to a problem either with the blower that gets the heat from the source or else the distribution system that carries it around the house. A fault in the thermostat will cause the unit not to switch itself off and on as it should in the heating cycle to control the level of heat in the house. So isolating the problem is the first step to solving it.
First off, check the power source for any blown fuses, and then try resetting the furnace or boiler using the reset button near the motor. The thermostat may not be set to the proper adjustment, so try raising or lowering it to see whether the unit will then activate. Check whether the pilot light is lit and that the gas supply is on, or in the case of oil that there is an adequate supply of it.
With gas heating systems you need to be especially careful, as the air quality is a major factor when these are replaced or undergo maintenance. By-products from the combustion process can damage your health, and ensuring that the chimney is unblocked and that there is proper ventilation for the gas heating system can help ensure no leakage of these harmful products into the home environment.
Keep an eye on the vent connection pipe and the condition of your chimney, as there is inevitable deterioration as time passes and repairs can be costly. In the case of the boiler or furnace, check the control settings for their provision of optimal temperature and water levels, and check for any cracks in the combustion chamber. Clean the blower and remove any debris such as soot that may have accumulated.
Just making a few regular checks to your boiler or furnace, and the distribution system of vents or pipes, will help maintain their condition and ensure a longer effective life.
Related Heating Information from Horizon Services...
Monday, October 4, 2010
Common Drain, Sewer and Water Line Problems
We Separate the Minor Inconveniences from the Major Headaches!Got a backed up or slow moving drain? A toilet that won't flush? Waste water that comes back up your sink, shower or tub drains? A foul smell in your yard or basement? JOIN THE CLUB! As the weather gets cooler, we at Horizon Services usually begin to see an increase in drain, sewer and water line service calls. For many homeowners, the recent intense rainfall and flood conditions in the Mid-Atlantic states -- particularly our service area of Delaware, Pennsylvania and Maryland -- have brought latent drain, sewer and water line problems that have been lurking invisibly in the shadows out into the open in a very dramatic fashion.
Face it...there are many things that can go wrong with your home's drain, sewer and water line system. For example, years of accumulated waste can cause major obstructions in pipes and lines. Old pipes and seals can crack, corrode or collapse. Tree roots can even infiltrate sewer and water lines These are the kinds of drain, sewer and water line problems that can require significant repair and expense.
The good news is that the majority of drain, sewer and water line issues are not that severe. Most are easily and inexpensively repaired. And most are preventable.
The vast majority of drain, sewer and water line problems are usually caused by minor incidents such as something falling down the pipe, clogging due to inappropriate matter being sent down the sink or toilet, and frozen pipes in colder weather.
Identifying the problem is the first step. Visually inspecting your sinks, tubs, showers, toilets and pipes will usually reveal the source of the problem. If the problem isn't deep down in your drains or lines, there's a good chance that you can resolve it yourself...or at least save time and money by pointing your drain or sewer/water line repairman in the right direction when they arrive at your home.
In the case of clogged sinks or toilets that won't flush, if the problem isn’t solved by using a plunger to unblock it, then the cause is probably due to an obstruction further down the line. You can use a plumber's snake or coiled wire (available at most hardware stores) to probe into the drain and get to where a basic plunger cannot to remove the obstruction. If this doesn’t work, your next step may be to remove the toilet bowl or sink to get access to the main pipe. This can be a delicate job, so it is best to call in a professional plumber or drain professional at this point.
In cold weather, frozen pipes is one of the most common causes of backed-up or slow moving drains. This is especially common when homeowners have been away for some time and turned the thermostat right down. Water moving slowly and at a low temperature causes ice to form and expand, causing blockages that exert increasing pressure on the pipes. Wrap the pipes in special wrap heat tape and leave it in place for at least 24 hours or until the blockage is cleared. Also consider leaving the thermostat at a higher setting to keep warm water circulating whilst you’re away for a while.
If you find that your boiler starts making a noise, this is probably because of hot spots forming due to a build up of steam, caused in turn by air building up in the system. The hot spots sometimes make banging noises when they get too hot, which is where the noise in the boiler comes from. The root cause of the build up of air is a lack of water in the system, but it can also be caused by a build up of scale on the inner surface of the boiler, in which case feed a boiler cleanser into the expansion.
Drainage pipes helpfully tend to run in straight lines, which facilitate the sorting out of problems. Inspection chambers covered by manhole covers are placed at each joint, and these covers can be lifted with a crowbar to check for blockages and to clean the manhole of accumulated debris where necessary. If you find the inspection chamber empty, the blockage must be closer to the house, so move on to the next one in that direction, and if it is full move in the opposite direction to look for the blockage. Once the blockage area has been isolated, you can insert the plumber' snake down the pipe in the direction of the blockage to clear it.
The drain cleaning and sewer/water line repair professionals at Horizon Services encourage all homeowners especially cognizant, vigilant and proactive in the maintenance of their home's drains, pipes and lines. Be aware of what you are putting down sinks, garbage disposals and toilets -- particularly large solid objects, grease and hair. Keep your eyes and ears open for the signs of drain, sewer and water line damage or obstruction. Insulate your pipes in cold weather. If you suspect a problem, don't delay -- call a drain cleaning or sewer & water line contractor immediately to fix the problem before it becomes large and expensive.
Related Information from Horizon Services...
Monday, July 26, 2010
Do You Need a Sewer Line Replacement?
The last thing any homeowner wants to deal with is a backed up main sewer line. But sewer line replacement is costly, and the repair process can be invasive. The key to avoiding a disaster is properly diagnosing the cause of your home’s drainage problems.Slow-moving drains or a toilet that takes forever to flush are pretty good indications that something is not quite right with your home’s drainage system. Still, it’s important to figure out if the issue is simply a blockage at the fixture or a more serious problem.
Because toilets send such a large volume of water into the sewer line so suddenly, this is the most obvious place to start if you suspect your sewer line has been compromised. If your toilet is slow to flush or the bowl fills up upon flushing rather them emptying, try plunging the toilet with a handheld plunger. If that doesn’t seem to help, check the other drains throughout the house.
Does the kitchen sink fill with water when the tap is turned on? Does your shower or tub drain seem to back up when the water is running? Is there standing water in your dishwasher or washing machine following a cycle? Affirmative answers to any of these questions strongly suggest that your home’s sewer line is in need of repair.
If every drain in your house is slow to empty, you should consult a reputable sewer line repair and replacement service for further diagnostics. As long as there’s no waste or standing water build-up in your yard or around your septic tank, a sewer line specialist will likely examine pipe couplings inside your house to check for blockages in the pipes. By opening the drain line inside the house, the sewer line specialist can determine if the blockage is close to your home or further out into the sewer line. This can also help reveal how serious the blockage is—if water spills from the open coupling then it’s safe to say the problem is substantial, as standing water in the drain line nearest the house indicates that waste water has been backing up from the sewer or septic tank all the way into the home for some time.
Your sewer line specialist will also conduct a visual inspection of drain pipes inside your home, looking for evidence of leaks and overflowing water that likely indicate a sewer line blockage. In most cases, this will require a special sewer line camera that can be fed through the entire length of the sewer line.
Once it’s been determined that your sewer line is blocked or damaged, a sewer line professional can judge how far along the line the problem is. The sewer line technician will follow the piping and take into account the position of the septic tank or sewer to figure out the most likely spot of the damage.
If the issue is not in your home but further down the line toward the sewer or septic system, chances are root infiltration, aging pipes, a broken pipe, or some other physical damage has caused the line to malfunction. Repair or replacing may involve tearing up your lawn surrounding the pipe, replacing the damaged portion, reburying the site, and re-seeding the yard. Some sewer line specialists, like Horizon Services, employ a trenchless system which can repair or replace the sewer line without tearing your yard up.
Related Information from Horizon Services...
Subscribe to:
Posts (Atom)
Subscribe!
Posts
All Comments
My Blog List
AddThis
Keystone Partner
Horizon Services is a Keystone Partner of Philadelphia Union, Major League Soccer Team
